If you want to keep your valuables and properties safe, using a security alarm system is the first line of defense. It deters crime, allows remote access to your home, notifies if there is a gas or fire burst-out, and you can also keep your eyes on your kids.
But the best one is that it makes room for peace of mind. Indeed, they are beneficial, but many people find them difficult to install. This article is going to guide you with the steps to install a security alarm system.
Go through the manual:
The very first step is to go through the installation manual carefully that comes with the security alarm installation kit.
If you require anything else for the installation purpose, which is not included in the kit, contact the local officials. For any query, you may have a conversation with the product’s manufacturer.
Choose a proper place to install:
The next step is to determine a place to install an alarm keypad. Make sure that the wiring installation is not kept parallel to any high voltage electrical wiring. It is so because that it may cause interference and give off false alarms.
Remember that the control panel also requires a place to get installed. The motion detectors and sirens require an area where there is low interference of wires and any other types of equipment.
Fasten the control panel:
Level and mark on the wall where you want to install the control panel. You will also need to drill holes in the wall or sheetrock. Install the anchors properly. Then fasten the control panel to the wall.
The best place to fit the home security panel is near the primary entry door. Close the power source before installing the panel. If you can’t put holes in the wall, make use of double-sided adhesive.
Drill the necessary holes:
Being the indispensable part of the security alarm installation, sirens, keypads, power transformers, and motion sensors also require holes to get installed.
Thus, drill the necessary holes to fish the wires for the mentioned devices to connect them to the control panel. But, be careful while drilling, and make sure that you are not drilling into another wiring while performing this step.
Run wires, and place the detectors and sensors:
The system will include window and basic door sensors and may also include motion detectors. Place them in the optimum locations based on the provided guidelines. Run the wires for the devices like sirens, keypads, motion sensors, power transformers, and control panels.
Make sure that you are not tangling the wires while running them. It not only becomes messy, but you will also get confused about the different purposes of different wires and which wire to connect where.
Fasten the motherboard:
Securing the control panel to the wall is a vital step. Perform it carefully, and make sure that the screws are tight and it doesn’t get loosened with time. After securing the control panel properly, the motherboard needs to be fastened inside the control panel box.
The wiring connections need to be done properly at both the control panel and devices. Then, take a look at the instructions of the manufacturer, and program the alarm accordingly. Then finally, power it up.
After installing the alarm system, take some time to familiarize your family members with it. To test the system, you will need to follow the directions outlined in the system’s manual and make sure that everything is functioning properly. You may need to test the system for a couple of days to adjust.